Table of Contents
Advertisement
Extracting Operational Code from .stk file...done.
Loading Operational Code...done.
Decompressing Operational Code...done.
Scanning devshell symbols file...
47544 symbols, loading...
Done.
PCI unit 0: Dev 0xb842, Rev 0x02, Chip BCM56842_A0, Driver BCM56840_B0
SOC unit 0 attached to PCI device BCM56842_A0
Adding BCM transport pointers
Configuring CPUTRANS TX
Configuring CPUTRANS RX
<186> Aug 26 08:18:23 0.0.0.0-1 General[72162340]: bootos.c(166) 4 %%
Event(0xaaaaaaaa)
(Unit 1 - Waiting to select management unit)>
Applying Global configuration, please wait ...
Applying Interface configuration, please wait ...
Boot Utility Menu
If a user is connected through the serial interface during the boot sequence,
the operator is presented with the option to enter the Boot Utility Menu
during the boot sequence. Selecting item 2 displays the menu and may be
typed only during the initial boot up sequence.
Select startup option within 5 seconds, else Operational Code will start
automatically...
Operational Code Startup -- Main Menu
1 - Start Operational Code
2 - Display Boot Menu
Select (1, 2)# 2
Enter the Boot Menu password:calvin
Boot Menu Rev: 6.0
Operational Code -- Boot Main Menu
1
- Start Operational Code
2
- Select Baud Rate
3
- Retrieve Logs
4
- Load New Operational Code
5
- Display Operational Code Details
9
- Reboot
10
- Restore Configuration to Factory Defaults
started!
Using the CLI
252
Advertisement
Table of Contents
