Dell N1100-ON Reference Manual page 202

Command
test copper-port tdr
a. For the meaning of each Mode abbreviation, see
Power Over Ethernet (PoE)
Command
power inline
power inline detection
power inline four-pair
forced
power inline limit
power inline management
power inline powered-
device
power inline priority
power inline reset
power inline usage-
threshold
clear power inline statistics
show power inline
show power inline
firmware-version
a. For the meaning of each Mode abbreviation, see
Description
Diagnoses with TDR (Time Domain
Reflectometry) technology the quality and
characteristics of a copper cable attached to a
port.
Mode
Description
Enables/disables the ability of the port to
deliver power.
Configures the detection type that tells
which types of PD's will be detected and
powered by the switch.
Forces 4-pair power feed on an interface.
Configure the type of power limit.
Sets the power management type.
Adds a comment or description of the
powered device type.
Configures the port priority level for the
delivery of power to an attached device.
Use to reset the port.
Configures the system power usage
threshold level at which lower priority
ports are disconnected.
Clears the PoE statistics.
Reports current PoE configuration and
status.
Displays the version of the PoE controller
firmware present on the switch file system.
Mode
Types.
Types.
Dell EMC Networking CLI
a
Mode
PE
a
Mode
IC
(Ethernet)
IC
IC
IC
GC
IC
(Ethernet)
IC
(Ethernet)
IC
GC
PE
PE
PE
202