Dell N1100-ON Reference Manual page 142

Command
tacacs-server source-
interface
tacacs-server timeout
timeout
a. For the meaning of each Mode abbreviation, see
802.1x
Command
dot1x dynamic-vlan enable
dot1x eapolflood
dot1x initialize
dot1x mac-auth-bypass
dot1x max-req
dot1x max-users
dot1x port-control
dot1x re-authenticate
dot1x reauthentication
dot1x system-auth-control
monitor
Description
Selects the interface from which to use the IP
address in the source IP address field of
transmitted TACACS packets.
Sets the interval for which the switch waits for a
server host to reply.
Specifies the timeout value in seconds.
Mode
Description
Enables the capability of creating VLANs
dynamically when a RADIUS-assigned VLAN
does not exist in the switch.
Enables the flooding of received IEEE 802.1x
frames in the VLAN.
Begins the initialization sequence on the
specified port.
Enables MAB on an interface.
Sets the maximum number of times the switch
sends an EAP-request frame to the client before
restarting the authentication process.
Sets the maximum number of clients supported
on the port when MAC-based 802.1X
authentication is enabled on the port.
Enables manual control of the authorization
state of the port.
Manually initiates a reauthentication of all
802.1x-enabled ports or a specified 802.1X
enabled port.
Enables periodic reauthentication of the client. IC
Enables 802.1X globally.
Types.
Dell EMC Networking CLI
a
Mode
GC
GC
TC
a
Mode
GC
GC
PE
IC
IC
IC
IC
PE
GC
142