Show Lacp - Cisco WLC 5700 Series Command Reference Manual

Layer 2/3 Commands

show lacp

To display Link Aggregation Control Protocol (LACP) channel-group information, use the show lacp command
in user EXEC mode.
show lacp [channel-group-number] {counters| internal| neighbor| sys-id}
Syntax Description
channel-group-number
counters
internal
neighbor
sys-id
Command Default
None
Command Modes
User EXEC
Command History
Release
Cisco IOS XE 3.2SE
Usage Guidelines
You can enter any show lacp command to display the active channel-group information. To display specific
channel information, enter the show lacp command with a channel-group number.
If you do not specify a channel group, information for all channel groups appears.
You can enter the channel-group-number to specify a channel group for all keywords except sys-id.
Examples This is an example of output from the show lacp counters user EXEC command. The table that follows
describes the fields in the display.
Controller> show lacp counters
Port
---------------------------------------------------------------------
Channel group:1
Gi2/0/1
Gi2/0/2
OL-32323-01
(Optional) Channel group number. The range is 1 to 128.
Displays traffic information.
Displays internal information.
Displays neighbor information.
Displays the system identifier that is being used by LACP. The system
identifier consists of the LACP system priority and the controller MAC
address.
LACPDUs Marker
Sent Recv Sent Recv
19 10 0 0
14 6 0 0
Layer 2/3 Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
Modification
This command was introduced.
Marker Response LACPDUs
Sent Recv Pkts Err
0 0 0
0 0 0

show lacp

47