Configuring Bfd For Rip (Single Hop Echo Detection For A Specific Destination) - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

<SwitchA> display ip routing-table 120.1.1.0 24 verbose
Summary Count : 1
Destination: 120.1.1.0/24
Protocol: RIP
SubProtID: 0x1
Cost: 1
Tag: 0
OrigTblID: 0x0
TableID: 0x2
NBRID: 0x26000002
AttrID: 0xffffffff
Flags: 0x1008c
Label: NULL
BkLabel: NULL
Tunnel ID: Invalid
BkTunnel ID: Invalid
The output shows that Switch A communicates with Switch C through VLAN-interface 200.
Configuring BFD for RIP (single hop echo detection for a
specific destination)
Network requirements
As shown in
200 of Switch B and Switch C runs RIP process 1.
Configure a static route destined for 100.1.1.0/24 and enable static route redistribution into RIP on both
Switch A and Switch C so Switch B can learn two routes destined for 100.1.1.0/24 through
VLAN-interface 100 and VLAN-interface 200. The route redistributed from Switch A has a smaller cost
than that redistributed from Switch C, so Switch B uses the route through VLAN-interface 200.
Enable BFD for RIP on VLAN-interface 100 of Switch A, and specify VLAN-interface 100 of Switch B as
the destination. When a unidirectional link occurs (packets from Switch A can reach Switch B, but
packets from Switch B cannot reach Switch A), BFD can quickly detect the link failure and notify RIP.
Switch B then deletes the neighbor relationship and the route information learned on VLAN-interface 100,
and does not receive or send any packets from VLAN-interface 100. When the route learned from Switch
A ages out, Switch B uses the route destined for 100.1.1.1 24 through VLAN-interface 200.
Process ID: 2
Preference: 100
OrigNextHop: 192.168.2.2
RealNextHop: 192.168.2.2
BkInterface: N/A
Figure 12, VLAN-interface 100 of Switch A and Switch B runs RIP process 1. VLAN-interface
Age: 04h20m37s
State: Active Adv
OrigVrf: default-vrf
OrigAs: 0
LastAs: 0
Neighbor: 192.168.2.2
BkNextHop: N/A
Interface: Vlan-interface200
50