Configuring The Maximum Lifetime For Routes In The Fib; Configuring The Maximum Number Of Ecmp Routes - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Configuring the maximum lifetime for routes in the
FIB
When GR or NSR is disabled, FIB entries must be retained for some time after a protocol process
switchover or RIB process switchover. When GR or NSR is enabled, FIB entries must be removed
immediately after a protocol or RIB process switchover to avoid routing issues. Perform this task to meet
such requirements.
To configure the maximum lifetime for routes in the FIB (IPv4):
Step
1. Enter system view.
2. Enter RIB view.
3. Create a RIB IPv4 address
family and enter its view.
4. Configure the maximum
lifetime for IPv4 routes in the
FIB.
To configure the maximum lifetime for routes in the FIB (IPv6):
Step
1. Enter system view.
2. Enter RIB view.
3. Create a RIB IPv6 address
family and enter its view.
4. Configure the maximum
lifetime for IPv6 routes in the
FIB.

Configuring the maximum number of ECMP routes

This configuration takes effect at next reboot. Make sure the reboot does not impact your network.
To configure the maximum number of ECMP routes:
Step
1. Enter system view.
2. Configure the maximum
number of ECMP routes.
Command
system-view
Rib
address-family ipv4
fib lifetime seconds
Command
system-view
Rib
address-family ipv6
fib lifetime seconds
Command
system-view
max-ecmp-num number
5
Remarks
N/A
N/A
By default, no RIB IPv4
address family is created.
By default, the maximum
lifetime for routes in the FIB is
600 seconds.
Remarks
N/A
N/A
By default, no RIB IPv6
address family is created.
By default, the maximum
lifetime for routes in the FIB is
600 seconds.
Remarks
N/A
By default, the maximum
number of ECMP routes is 8.