Ipv4 Bgp Configuration Examples; Basic Bgp Configuration Example - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Task
Display the incoming label of BGP IPv6
unicast routing information.
Display the outgoing label of BGP IPv6
unicast routing information.
Display information about routes
advertised by the network command and
shortcut routes configured by the network
short-cut command.
Display BGP path attribute information.
Display BGP IPv6 unicast address family
update group information.
Reset IPv6 unicast BGP sessions.
Clear dampened BGP IPv6 unicast routing
information and release suppressed
routes.
Clear BGP IPv6 unicast route flap
information.

IPv4 BGP configuration examples

Basic BGP configuration example

Network requirements
In Figure 63, run EBGP between Switch A and Switch B, and run IBGP between Switch B and Switch C
so that Switch C can access the network 8.1.1.0/24 connected to Switch A.
Figure 63 Network diagram
Configuration considerations
To prevent route flapping caused by port state changes, this example uses loopback interfaces to
establish IBGP connections. Because loopback interfaces are virtual interfaces, use the peer
Command
display bgp routing-table ipv6 [ unicast ] inlabel
display bgp routing-table ipv6 [ unicast ] outlabel
display bgp network ipv6 [ unicast ] [ vpn-instance
vpn-instance-name ]
display bgp paths [ as-regular-expression ]
display bgp update-group ipv6 [ unicast ] [ ip-address |
ipv6-address ]
display bgp update-group ipv6 [ unicast ] vpn-instance
vpn-instance-name [ ipv6-address ]
reset bgp { as-number | ipv6-address | all | external | group
group-name | internal } ipv6 [ unicast ] [ vpn-instance
vpn-instance-name ]
reset bgp ip-address ipv6 [ unicast ]
reset bgp dampening ipv6 [ unicast ] [ vpn-instance
vpn-instance-name ] [ network-address prefix-length ]
reset bgp flap-info ipv6 [ unicast ] [ vpn-instance
vpn-instance-name ] [ network-address prefix-length | as-path-acl
as-path-acl-number | peer ipv6-address ]
257