HP 6125XLG Layer 3 - Ip Routing Configuration Manual page 299

[SwitchC-bgp-ipv4] peer 3.0.1.1 enable
[SwitchC-bgp-ipv4] peer 2.0.1.1 enable
[SwitchC-bgp-ipv4] quit
[SwitchC-bgp] quit
# Enable BFD for peer 3.0.1.1.
[SwitchC-bgp] peer 3.0.1.1 bfd
[SwitchC-bgp] quit
[SwitchC] quit
Verifying the configuration
# Display detailed BFD session information on Switch C.
<SwitchC> display bfd session verbose
Total Session Num: 1
IPv4 Session Working Under Ctrl Mode:
Session State: Up
The output shows that a BFD session has been established between Switch A and Switch C.
# Display BGP peer information on Switch C.
<SwitchC> display bgp peer ipv4
BGP local router ID: 3.3.3.3
Local AS number: 200
Total number of peers: 2
Peer
2.0.1.1
3.0.1.1
The output shows that Switch C has established two BGP connections with Switch A, and both
connections are in Established state.
# Display route 1.1.1.0/24 on Switch C.
<SwitchC> display ip routing-table 1.1.1.0 24 verbose
Summary Count : 1
Destination: 1.1.1.0/24
Local Discr: 513
Source IP: 3.0.2.2
Min Tx Inter: 500ms
Min Rx Inter: 500ms
Rx Count: 135
Connect Type: Indirect
Hold Time: 2457ms
Detect Mode: Async
Protocol: BGP
Diag Info: No Diagnostic
Up Session Num: 1
Remote Discr: 513
Destination IP: 3.0.1.1
Act Tx Inter: 500ms
Detect Inter: 2500ms
Running Up for: 00:00:58
Peers in established state: 2
AS MsgRcvd MsgSent OutQ PrefRcv Up/Down
200 4
200 4
287
Init Mode: Active
Interface: N/A
Tx Count: 135
Auth mode: None
Slot: 0
5 0 0 00:01:55 Established
5 0 0 00:01:52 Established
State