Bgp And Igp Route Redistribution Configuration Example - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Network
* >e 2.2.2.2/32
* >e 3.1.1.0/24
* > 8.1.1.0/24
* >e 9.1.1.0/24
Two routes, 2.2.2.2/32 and 9.1.1.0/24, have been added in Switch A's routing table.
# Display the BGP routing table on Switch C.
[SwitchC] display bgp routing-table ipv4
Total number of routes: 4
BGP local router ID is 3.3.3.3
Status codes: * - valid, > - best, d - dampened, h - history,
Network
* >i 2.2.2.2/32
* >i 3.1.1.0/24
* >i 8.1.1.0/24
* >i 9.1.1.0/24
The output shows that the route 8.1.1.0 becomes valid with the next hop as Switch A.
Verifying the configuration
# Ping 8.1.1.1 on Switch C.
[SwitchC] ping 8.1.1.1
Ping 8.1.1.1 (8.1.1.1): 56 data bytes, press CTRL_C to break
56 bytes from 8.1.1.1: icmp_seq=0 ttl=254 time=10.000 ms
56 bytes from 8.1.1.1: icmp_seq=1 ttl=254 time=4.000 ms
56 bytes from 8.1.1.1: icmp_seq=2 ttl=254 time=4.000 ms
56 bytes from 8.1.1.1: icmp_seq=3 ttl=254 time=3.000 ms
56 bytes from 8.1.1.1: icmp_seq=4 ttl=254 time=3.000 ms
--- Ping statistics for 8.1.1.1 ---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/std-dev = 3.000/4.800/10.000/2.638 ms

BGP and IGP route redistribution configuration example

Network requirements
As shown in
belong to AS 65009. AS 65008 and AS 65009 are connected through Switch A and Switch B. It is
required that Switch A can access network 9.1.2.0/24 in AS 65009, and Switch C can access network
8.1.1.0/24 in AS 65008.
Origin: i - IGP, e - EGP, ? - incomplete
NextHop
3.1.1.1
3.1.1.1
8.1.1.1
3.1.1.1
s - suppressed, S - stale, i - internal, e - external
Origin: i - IGP, e - EGP, ? - incomplete
NextHop
2.2.2.2
2.2.2.2
3.1.1.2
2.2.2.2
Figure 64, all devices of company A belong to AS 65008, and all devices of company B
MED LocPrf
0
0
0
0
MED LocPrf
0 100
0 100
0 100
0 100
261
PrefVal Path/Ogn
0 65009?
0 65009?
32768 i
0 65009?
PrefVal Path/Ogn
0 ?
0 ?
0 65008i
0 ?