Configuring Pbr; Introduction To Pbr; Policy - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Blade switch
Hide thumbs Also See for 6125XLG:
Table of Contents

Advertisement

Configuring PBR

Introduction to PBR

Policy-based routing (PBR) uses user-defined policies to route packets. A policy can specify the next hop
for packets that match specific criteria such as ACLs.
A device forwards received packets using the following process:
1.
The device uses PBR to forward matching packets.
2.
If the packets do not match the PBR policy or the PBR-based forwarding fails, the device uses the
routing table, excluding the default route, to forward the packets.
3.
If the routing table-based forwarding fails, the device uses the default next hop or default output
interface defined in PBR to forward packets.
4.
If the default next hop or default output interface-based forwarding fails, the device uses the default
route to forward packets.
PBR includes local PBR and interface PBR:
Local PBR guides the forwarding of locally generated packets, such as the ICMP packets generated
by using the ping command.
Interface PBR guides the forwarding of packets received on an interface only.

Policy

A policy includes match criteria and actions to be taken on the matching packets. A policy can have one
or multiple nodes as follows:
Each node is identified by a node number. A smaller node number has a higher priority.
A node contains if-match and apply clauses. An if-match clause specifies a match criterion, and an
apply clause specifies an action.
A node has a match mode of permit or deny.
A policy matches nodes in priority order against packets. If a packet matches the criteria on a node, it
is processed by the action on the node. Otherwise, it goes to the next node for a match. If the packet does
not match the criteria on any node, it is forwarded according to the routing table.
if-match clause
PBR supports the if-match acl clause to set an ACL match criterion. You can specify only one if-match acl
clause for a node.
apply clause
PBR supports the apply next-hop clause to set next hops for packets.
314

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5920 series5900 series

Table of Contents