Configuring Ipv6 Pbr; Configuring Ipv6 Local Pbr; Configuring Ipv6 Interface Pbr - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Step
3. Set next hops for
permitted IPv6
packets.

Configuring IPv6 PBR

Configuring IPv6 local PBR

Configure IPv6 PBR by applying a policy locally. IPv6 PBR uses the policy to guide the forwarding of
locally generated packets. The specified policy must already exist. Otherwise, the IPv6 local PBR
configuration fails.
You can apply only one policy locally. Before you apply a new policy, you must first remove the current
policy.
Do not configure IPv6 local PBR unless required.
To configure IPv6 local PBR:
Step
1. Enter system view.
2. Apply a policy locally.

Configuring IPv6 interface PBR

Configure IPv6 PBR by applying an IPv6 policy to an interface. IPv6 PBR uses the policy to guide the
forwarding of IPv6 packets received on the interface. The specified policy must already exist. Otherwise,
the IPv6 interface PBR configuration fails.
You can apply only one policy to an interface. Before you apply a new policy, you must first remove the
current policy from the interface.
You can apply a policy to multiple interfaces.
To configure IPv6 interface PBR:
Step
Enter system view.
1.
2. Enter interface view.
3. Apply an IPv6
policy to the
interface.
Command
apply next-hop [ vpn-instance
vpn-instance-name ] { ipv6-address [ direct ]
[ track track-entry-number ] }&<1-n>
Command
system-view
ipv6 local policy-based-route
policy-name
Command
system-view
interface interface-type interface-number
ipv6 policy-based-route policy-name
410
Remarks
By default, no next hop is specified.
You can specify multiple next hops for
backup or load sharing by executing
this command once or multiple times.
You can specify a maximum of two
next hops for a node.
Remarks
N/A
By default, no policy is locally
applied.
Remarks
N/A
N/A
By default, no IPv6 policy is
applied to the interface.