Ripng Route Redistribution Configuration Examples - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

via FE80::200:2FF:FE64:8904, cost 1, tag 0, AOF, 31 secs
Destination 4::/64,
via FE80::200:2FF:FE64:8904, cost 2, tag 0, AOF, 31 secs
Destination 5::/64,
via FE80::200:2FF:FE64:8904, cost 2, tag 0, AOF, 31 secs
3. Configure route filtering:
# Use IPv6 prefix lists on Switch B to filter received and redistributed routes.
[SwitchB] ipv6 prefix-list aaa permit 4:: 64
[SwitchB] ipv6 prefix-list bbb deny 2:: 64
[SwitchB] ipv6 prefix-list bbb permit :: 0 less-equal 128
[SwitchB] ripng 1
[SwitchB-ripng-1] filter-policy prefix-list aaa export
[SwitchB-ripng-1] filter-policy prefix-list bbb import
[SwitchB-ripng-1] quit
# Display RIPng routing tables on Switch B and Switch A.
[SwitchB] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::1:100 on Vlan-interface100
Destination 1::/64,
via FE80::2:100, cost 1, tag 0, AOF, 6 secs
Peer FE80::3:200 on Vlan-interface200
Destination 3::/64,
via FE80::2:200, cost 1, tag 0, AOF, 11 secs
Destination 4::/64,
via FE80::2:200, cost 1, tag 0, AOF, 11 secs
Destination 5::/64,
via FE80::2:200, cost 1, tag 0, AOF, 11 secs
[SwitchA] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::2:100 on Vlan-interface100
Destination 4::/64,
via FE80::1:100, cost 2, tag 0, AOF, 2 secs

RIPng route redistribution configuration examples

Network requirements
As shown in
through RIPng 200.
Configure route redistribution on Switch B, so the two RIPng processes can redistribute routes from each
other.
O - Optimal, F - Flush to RIB
O - Optimal, F - Flush to RIB
Figure 86, Switch B communicates with Switch A through RIPng 100 and with Switch C
344