Configuring A Dr Priority For An Interface; Ignoring Mtu Check For Dd Packets; Disabling Interfaces From Receiving And Sending Ospfv3 Packets - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

To configure the LSA generation interval:
Step
1. Enter system view.
2. Enter OSPFv3 view.
3. Configure the LSA
generation interval.

Configuring a DR priority for an interface

The router priority is used for DR election. Interfaces having the priority 0 cannot become a DR or BDR.
To configure a DR priority for an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Configure a router priority.

Ignoring MTU check for DD packets

When LSAs are few in DD packets, it is unnecessary to check the MTU in DD packets to improve
efficiency.
To ignore MTU check for DD packets:
Step
1. Enter system view.
2. Enter interface view.
3. Ignore MTU check for DD
packets.
Disabling interfaces from receiving and sending OSPFv3
packets
After an OSPFv3 interface is set to silent, direct routes of the interface can still be advertised in
Intra-Area-Prefix LSAs through other interfaces, but other OSPFv3 packets cannot be advertised. No
neighboring relationship can be established on the interface. This feature can enhance the adaptability
of OSPFv3 networking.
To disable interfaces from receiving and sending OSPFv3 packets:
Command
system-view
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
lsa-generation-interval
maximum-interval [ minimum-interval
[ incremental-interval ] ]
Command
system-view
interface interface-type interface-number
ospfv3 dr-priority priority [ instance
instance-id ]
Command
system-view
interface interface-type
interface-number
ospfv3 mtu-ignore [ instance
instance-id ]
362
Remarks
N/A
N/A
By default, the maximum interval is 5
seconds, the minimum interval is 0
milliseconds, and the incremental
interval is 0 milliseconds.
Remarks
N/A
N/A
The default router priority
is 1.
Remarks
N/A
N/A
By default, OSPFv3 does not
ignore MTU check for DD packets.