HP 6125XLG Layer 3 - Ip Routing Configuration Manual page 390

[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] ospfv3 1 area 0
[SwitchB-Vlan-interface200] quit
# Configure Switch C: enable OSPFv3 and specify the router ID as 3.3.3.3.
<SwitchC> system-view
[SwitchC] ospfv3
[SwitchC-ospfv3-1] router-id 3.3.3.3
[SwitchC-ospfv3-1] quit
[SwitchC] interface vlan-interface 100
[SwitchC-Vlan-interface100] ospfv3 1 area 0
[SwitchC-Vlan-interface100] quit
# Configure Switch D: enable OSPFv3 and specify the router ID as 4.4.4.4.
<SwitchD> system-view
[SwitchD] ospfv3
[SwitchD-ospfv3-1] router-id 4.4.4.4
[SwitchD-ospfv3-1] quit
[SwitchD] interface vlan-interface 200
[SwitchD-Vlan-interface200] ospfv3 1 area 0
[SwitchD-Vlan-interface200] quit
# Display neighbor information on Switch A. The switches have the same default DR priority 1, so
Switch D (the switch with the highest Router ID) is elected as the DR, and Switch C is the BDR.
[SwitchA] display ospfv3 peer
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
2.2.2.2
3.3.3.3
4.4.4.4
# Display neighbor information on Switch D. The neighbor states are all full.
[SwitchD] display ospfv3 peer
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
1.1.1.1
2.2.2.2
3.3.3.3
3. Configure router priorities for interfaces:
# Configure the router priority of VLAN-interface 100 as 100 on Switch A.
[SwitchA] interface Vlan-interface 100
[SwitchA-Vlan-interface100] ospfv3 dr-priority 100
[SwitchA-Vlan-interface100] quit
OSPFv3 Process 1 with Router ID 1.1.1.1
Pri State
1 2-Way/DROther
1 Full/BDR
1 Full/DR
OSPFv3 Process 1 with Router ID 4.4.4.4
Pri State
1 Full/DROther
1 Full/DROther
1 Full/BDR
378
Dead-Time InstID Interface
00:00:36 0 Vlan200
00:00:35 0 Vlan100
00:00:33 0 Vlan200
Dead-Time InstID Interface
00:00:30 0 Vlan100
00:00:37 0 Vlan200
00:00:31 0 Vlan100