Ospfv3 Route Redistribution Configuration Example - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
1.1.1.1
2.2.2.2
3.3.3.3
The output shows that Switch A becomes the DR.

OSPFv3 route redistribution configuration example

Network requirements
As shown in
• Switch A, Switch B, and Switch C are in Area 2.
OSPFv3 process 1 and OSPFv3 process 2 run on Switch B. Switch B communicates with Switch A
•
and Switch C through OSPFv3 process 1 and OSPFv3 process 2.
Configure OSPFv3 process 2 to redistribute direct routes and the routes from OSPFv3 process 1 on
•
Switch B, and set the default metric for redistributed routes to 3. Switch C can then learn the routes
destined for 1::0/64 and 2::0/64, and Switch A cannot learn the routes destined for 3::0/64 or
4::0/64.
Figure 91 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic OSPFv3:
# Enable OSPFv3 process 1 on Switch A.
<SwitchA> system-view
[SwitchA] ospfv3 1
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ospfv3 1 area 2
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] ospfv3 1 area 2
OSPFv3 Process 1 with Router ID 4.4.4.4
Pri State
100 Full/DR
0 2-Way/DROther
2 Full/BDR
Figure 91:
Dead-Time InstID Interface
00:00:30 0
00:00:37 0
00:00:31 0
380
Vlan100
Vlan200
Vlan100