Ripng Ipsec Profile Configuration Examples - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Destination: 1::1/128
NextHop
Interface
Destination: 2::/64
NextHop
Interface
Destination: 2::1/128
NextHop
Interface
Destination: 4::/64
NextHop
Interface
Destination: FE80::/10
NextHop
Interface
Destination: FF00::/8
NextHop
Interface

RIPng IPsec profile configuration examples

Network requirements
As shown in
authenticate and encrypt protocol packets.
Figure 87 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure RIPng basic functions:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ripng 1
[SwitchA-ripng-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ripng 1 enable
[SwitchA-Vlan-interface100] quit
: ::1
: InLoop0
: 2::1
: Vlan200
: ::1
: InLoop0
: FE80::200:BFF:FE01:1C02
: Vlan100
: ::
: NULL0
: ::
: NULL0
Figure 87, configure RIPng on the switches, and configure IPsec profiles on the switches to
347
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : RIPng
Preference: 100
Cost : 1
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0