HP 6125XLG Layer 3 - Ip Routing Configuration Manual page 122

[SwitchC-ospf-1-area-0.0.0.0] quit
[SwitchC-ospf-1] quit
# Configure Switch D.
<SwitchD> system-view
[SwitchD] router id 4.4.4.4
[SwitchD] ospf
[SwitchD-ospf-1] area 0
[SwitchD-ospf-1-area-0.0.0.0] network 192.168.1.0 0.0.0.255
[SwitchD-ospf-1-area-0.0.0.0] quit
[SwitchD-ospf-1] return
# Display OSPF neighbor information of Switch A.
[SwitchA] display ospf peer verbose
OSPF Process 1 with Router ID 1.1.1.1
Area 0.0.0.0 interface 192.168.1.1(Vlan-interface1)'s neighbors
Router ID: 2.2.2.2
State: 2-Way
DR: 192.168.1.4
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 38
Neighbor is up for 00:01:31
Authentication Sequence: [ 0 ]
Router ID: 3.3.3.3
State: Full
DR: 192.168.1.4
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 31
Neighbor is up for 00:01:28
Authentication Sequence: [ 0 ]
Router ID: 4.4.4.4
State: Full
DR: 192.168.1.4
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 31
Neighbor is up for 00:01:28
Authentication Sequence: [ 0 ]
The output shows that Switch D is the DR and Switch C is the BDR.
3. Configure router priorities on interfaces:
# Configure Switch A.
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] ospf dr-priority 100
[SwitchA-Vlan-interface1] quit
# Configure Switch B.
Neighbors
Address: 192.168.1.2
Mode: None Priority: 1
BDR: 192.168.1.3
sec
Address: 192.168.1.3
Mode: Nbr is Master
BDR: 192.168.1.3
sec
Address: 192.168.1.4
Mode: Nbr is Master
BDR: 192.168.1.3
sec
110
GR State: Normal
MTU: 0
GR State: Normal
Priority: 1
MTU: 0
GR State: Normal
Priority: 1
MTU: 0