Specifying Lsa Transmission Delay; Specifying Spf Calculation Interval; Specifying The Lsa Generation Interval - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Specifying LSA transmission delay

Each LSA in the LSDB has an age that is incremented by 1 every second, but the age does not change
during transmission. Therefore, it is necessary to add a transmission delay into the age time, especially
for low-speed links.
To specify the LSA transmission delay on an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Specify the LSA transmission
delay.

Specifying SPF calculation interval

LSDB changes result in SPF calculations. When the topology changes frequently, a large amount of
network and router resources are occupied by SPF calculation. You can adjust the SPF calculation interval
to reduce the impact.
When network changes are not frequent, the minimum-interval is adopted. If network changes become
frequent, the SPF calculation interval is incremented by incremental-interval × 2
generation times) each time an SPF calculation occurs until the maximum-interval is reached.
To configure SPF calculation interval:
Step
1. Enter system view.
2. Enter OSPFv3 view.
3. Specify the SPF
calculation interval.

Specifying the LSA generation interval

You can adjust the LSA generation interval to protect network resources and routers from being over
consumed by frequent network changes.
When network changes are not frequent, LSAs are generated at the minimum-interval. If network
changes become frequent, the LSA generation interval is incremented by incremental-interval × 2
the number of generation times) each time an LSA generation occurs until the maximum-interval is
reached.
Command
system-view
interface interface-type
interface-number
ospfv3 trans-delay seconds
[ instance instance-id ]
Command
system-view
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
spf-schedule-interval maximum-interval
[ minimum-interval
[ incremental-interval ] ]
361
Remarks
N/A
N/A
By default, the LSA transmission
delay is 1 second.
(n is the number of
n-2
Remarks
N/A
N/A
By default:
•
The maximum interval is 5
seconds.
•
The minimum interval is 50
milliseconds.
•
The incremental interval is 200
milliseconds.
(n is
n-2