HP 6125XLG Layer 3 - Ip Routing Configuration Manual page 52

Destination/Mask
10.0.0.0/8
The output shows that RIPv1 uses a natural mask.
3. Configure a RIP version:
# Configure RIPv2 on Switch A.
[SwitchA] rip
[SwitchA-rip-1] version 2
[SwitchA-rip-1] undo summary
[SwitchA-rip-1] quit
# Configure RIPv2 on Switch B.
[SwitchB] rip
[SwitchB-rip-1] version 2
[SwitchB-rip-1] undo summary
[SwitchB-rip-1] quit
# Display the RIP routing table on Switch A.
[SwitchA] display rip 1 route
Route Flags: R - RIP
A - Aging, S - Suppressed, G - Garbage-collect
O - Optimal, F - Flush to RIB
----------------------------------------------------------------------------
Peer 1.1.1.2 on Vlan-interface100
Destination/Mask
10.0.0.0/8
10.2.1.0/24
10.1.1.0/24
The output shows that RIPv2 uses classless subnet masks.
NOTE:
After RIPv2 is configured, RIPv1 routes might still exist in the routing table until they are aged out.
# Display the RIP routing table on Switch B.
Route Flags: R - RIP
A - Aging, S - Suppressed, G - Garbage-collect
O - Optimal, F - Flush to RIB
----------------------------------------------------------------------------
Peer 1.1.1.1 on Vlan-interface100
Destination/Mask
2.1.1.0/24
3.1.1.0/24
4. Configure route filtering:
# Reference IP prefix lists on Switch B to filter received and redistributed routes.
[SwitchB] ip prefix-list aaa index 10 permit 2.1.1.0 24
[SwitchB] ip prefix-list bbb index 10 permit 10.1.1.0 24
[SwitchB] rip 1
[SwitchB-rip-1] filter-policy prefix-list aaa import
[SwitchB-rip-1] filter-policy prefix-list bbb export
Nexthop Cost
1.1.1.2 1
Nexthop Cost
1.1.1.2 1
1.1.1.2 1
1.1.1.2 1
Nexthop Cost
1.1.1.1 1
1.1.1.1 1
40
Tag Flags Sec
0 RAOF 11
Tag Flags Sec
0 RAOF 50
0 RAOF 16
0 RAOF 16
Tag Flags Sec
0 RAOF 19
0 RAOF 19