Configure Bfd For Rip (Single-Hop Echo Detection For A Specific Destination) - HP VSR1000 Configuration Manual

SubProtID: 0x1
Cost: 1
Tag: 0
OrigTblID: 0x0
TableID: 0x2
NBRID: 0x26000002
AttrID: 0xffffffff
Flags: 0x1008c
Label: NULL
BkLabel: NULL
Tunnel ID: Invalid
BkTunnel ID: Invalid
The output shows that Router A communicates with Router C through GigabitEthernet 1/0. Then the link
over GigabitEthernet 1/0 fails.
# Display RIP routes destined for 120.1.1.0/24 on Router A.
<RouterA> display ip routing-table 120.1.1.0 24 verbose
Summary Count : 1
Destination: 120.1.1.0/24
Protocol: RIP
SubProtID: 0x1
Cost: 1
Tag: 0
OrigTblID: 0x0
TableID: 0x2
NBRID: 0x26000002
AttrID: 0xffffffff
Flags: 0x1008c
Label: NULL
BkLabel: NULL
Tunnel ID: Invalid
BkTunnel ID: Invalid
The output shows that Router A communicates with Router C through GigabitEthernet 2/0.
Configure BFD for RIP (single-hop echo detection for a specific
destination)
Network requirements
As shown in
process 1. GigabitEthernet 2/0 of Router B and Router C runs RIP process 1.
Configure a static route destined for 100.1.1.0/24 and enable static route redistribution into RIP on both
Router A and Router C so Router B can learn two routes destined for 100.1.1.0/24 through
GigabitEthernet 1/0 and GigabitEthernet 2/0. The route redistributed from Router A has a smaller cost
than that redistributed from Router C, so Router B uses the route through GigabitEthernet 1/0.
Preference: 100
OrigNextHop: 192.168.1.2
RealNextHop: 192.168.1.2
BkInterface: N/A
Process ID: 2
Preference: 100
OrigNextHop: 192.168.2.2
RealNextHop: 192.168.2.2
BkInterface: N/A
Figure 12, GigabitEthernet 2/0 of Router A and GigabitEthernet 1/0 of Router B run RIP
Age: 04h20m37s
State: Active Adv
OrigVrf: default-vrf
OrigAs: 0
LastAs: 0
Neighbor: 192.168.1.2
BkNextHop: N/A
Interface: GigabitEthernet1/0
Age: 04h20m37s
State: Active Adv
OrigVrf: default-vrf
OrigAs: 0
LastAs: 0
Neighbor: 192.168.2.2
BkNextHop: N/A
Interface: GigabitEthernet2/0
50