Configuring Is-Is Network Management - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Step
3. Enable IS-IS ISPF.

Configuring IS-IS network management

This task includes the following configurations:
Bind an IS-IS process to MIB so that you can use network management software to manage the
•
specified IS-IS process.
Enable IS-IS notifications to report important events.
•
Notifications are delivered to the SNMP module, which outputs the notifications according to the
configured output rules. For more information about SNMP notifications, see Network Management and
Monitoring Configuration Guide.
TRILL uses the IS-IS MIB to provide the TRILL object management function for NMS. Because the MIB
objects defined in the IS-IS MIB are single-instance management objects, NMS cannot manage IS-IS and
TRILL at the same time. According to the management for multiple OSPF instances defined in RFC 4750,
you can set a context name for the SNMP object for managing TRILL. In this way, the SNMP requests for
managing IS-IS and the SNMP requests for managing TRILL from NMS can be distinguished. Because the
context name is a concept specific to SNMPv3, the community names are mapped to context names for
distinguishing different protocols in SNMPv1/v2c.
To configure IS-IS network management:
Step
1. Enter system view.
2. Bind MIB to an IS-IS
process.
3. Enable IS-IS
notification sending.
4. Enter IS-IS view.
5. Configure the context
name for the SNMP
object for managing
IS-IS.
Command
ispf enable
Command
system-view
isis mib-binding process-id
snmp-agent trap enable isis
[ adjacency-state-change | area-mismatch
| authentication | authentication-type |
buffsize-mismatch | id-length-mismatch |
lsdboverload-state-change | lsp-corrupt |
lsp-parse-error | lsp-size-exceeded |
manual-address-drop | max-seq-exceeded
| maxarea-mismatch | own-lsp-purge |
protocol-support | rejected-adjacency |
skip-sequence-number | version-skew ] *
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
snmp context-name context-name
149
Remarks
By default, IS-IS is disabled.
Remarks
N/A
By default, MIB is bound to the IS-IS
process with the smallest process
ID.
By default, IS-IS notification
sending is enabled.
N/A
By default, no context name is set
for the SNMP object for managing
IS-IS.