Advertising A Default Route; Configuring Received/Redistributed Route Filtering - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

For example, RIPng has two specific routes to be advertised through an interface: 1:1 1:1 1::24 with a metric
of a 2 and 1:1 1:12::34 with a metric of 3. Configure route summarization on the interface, so RIPng
advertises a single route 1 1::0/16 with a metric of 2.
To configure RIPng route summarization:
Step
1. Enter system view.
2. Enter interface view.
3. Advertise a summary IPv6
prefix.

Advertising a default route

Step
1. Enter system view.
2. Enter interface view.
3. Configure RIPng to advertise a
default route.

Configuring received/redistributed route filtering

Perform this task to filter received or redistributed routes by using an IPv6 ACL or IPv6 prefix list. You can
also configure RIPng to filter routes redistributed from other routing protocols and routes from a specified
neighbor.
To configure a RIPng route filtering policy:
Step
1. Enter system view.
2. Enter RIPng view.
3. Configure a filter policy
to filter received routes.
4. Configure a filter policy
to filter redistributed
routes.
Command
system-view
interface interface-type interface-number
ripng summary-address ipv6-address
prefix-length
Command
system-view
interface interface-type
interface-number
ripng default-route { only |
originate } [ cost cost ]
Command
system-view
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
filter-policy { acl6-number | prefix-list
prefix-list-name } import
filter-policy { acl6-number | prefix-list
prefix-list-name } export [ protocol
[ process-id ] ]
337
Remarks
N/A
N/A
By default, the
summary IPv6 prefix
is not configured.
Remarks
N/A
N/A
By default, RIPng does not advertise a
default route.
This command advertises a default
route on the current interface
regardless of whether the default route
is available in the local IPv6 routing
table.
Remarks
N/A
N/A
By default, RIPng does not filter
received routes.
By default, RIPng does not filter
redistributed routes.