Enabling Ospf; Configuration Prerequisites; Configuration Guidelines - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Tasks at a glance
(Optional.)
•
Configuring OSPF timers
•
Specifying LSA transmission delay
•
Specifying SPF calculation interval
•
Specifying the LSA arrival interval
•
Specifying the LSA generation interval
•
Disabling interfaces from receiving and sending OSPF packets
•
Configuring stub routers
•
Configuring OSPF authentication
•
Adding the interface MTU into DD packets
•
Configuring a DSCP value for OSPF packets
•
Configuring the maximum number of external LSAs in LSDB
•
Configuring OSPF exit overflow interval
•
Enabling compatibility with RFC 1583
•
Logging neighbor state changes
•
Configuring OSPF network management
•
Configuring the LSU transmit rate
•
Enabling OSPF ISPF
•
Configuring prefix suppression
•
Configuring prefix prioritization
•
Configuring OSPF PIC
(Optional.)
•
Configuring the OSPF GR restarter
•
Configuring OSPF GR helper
•
Triggering OSPF GR
(Optional.)
(Optional.)
(Optional.)

Enabling OSPF

Enable OSPF before you perform other OSPF configuration tasks.

Configuration prerequisites

Configure the link layer protocol and IP addresses for interfaces to ensure IP connectivity between
neighboring nodes.

Configuration guidelines

To enable OSPF on an interface, you can enable OSPF on the network where the interface resides or
directly enable OSPF on that interface. If you configure both, the latter takes precedence.
Tuning and optimizing OSPF
Configuring OSPF GR
Configuring OSPF NSR
Configuring BFD for OSPF
Configuring OSPF FRR
networks:
67