4
Select the desired mode from the Special Features screen.
5
Set the desired mode.
For more information on setting each mode, see the corresponding section.
To set other modes at the same time, repeat steps 4 and 5.
6
Press
.
If the original is placed on the platen glass, follow the instructions that appear on the touch
panel display ➞ press
Scanning starts.
The scanned data is sent to the specified destination when scanning is complete.
NOTE
• To cancel this setting, follow the procedure below.
- For modes which have a right triangle ( ) on the bottom right of their key:
Example: Frame Erase
Press [Special Features]
- For modes which do not have a right triangle ( ) on the bottom right of their key:
Example: Job Build
Press [Special Features]
• To cancel the scan settings, press the Scan Settings drop-down list
• If [Preview] on the Send Settings screen is set, you can verify the images from the Preview
screen before sending your document. (See "Previewing Originals," on p. 5-21.)
• To cancel all settings and return the machine to the Standard mode, press
once for each original. When scanning is complete, press [Done].
➞
➞
[Frame Erase]
[Cancel].
➞
[Job Build].
➞
press [Option]
.
What are Special Features?
4
➞
[Cancel].
4-3