Related Manuals for Precor Elliptical Fitness Crosstrainer Experience 700 Series
Summary of Contents for Precor Elliptical Fitness Crosstrainer Experience 700 Series
- Page 1 Experience™ Series 700 Line Elliptical Fitness Crosstrainer™ (EFX) Assembly Guide Equati on 1: E nglis h...
- Page 3 Table of Languages English .................................. 1...
-
Page 4: Efx Assembly Guide
EFX Assembly Guide Follow the steps in the order listed in this assembly guide. For more product information, visit us at www.precor.com. WARNING At least two people are required to assemble the equipment. DO NOT attempt assembly by yourself. Assembly requirements Important Before you fully tighten a fastener, check that its head is flush with the surface of the equipment. - Page 5 Required tools Hex wrenches • #1 Phillips head screwdriver • 3/16-inch Fish tape (optional) • 5/32-inch 1/2-inch 9/16-inch Hardware kit Component Quantity Torque Component Quantity Torque Washer head screw 204 in-lb Self tapping pan 20 in-lb (5/16 x 3/4-inch) head screw (1/4 x .50)
-
Page 6: Begin Assembly
Begin Assembly WARNING DO NOT attempt to connect electrical power until all assembly procedures are complete and console is properly installed. DO NOT fully tighten the fasteners until instructed to do so. Have your assistant pull the console frame forward while you tighten the To begin assembly: ramp bolts using one wrench on the bottom nut and one on the top bolt. - Page 7 Screw the link arm into the base of the moving arm. To attach the moving arms: 4. Screw the link arm into the base of the moving arm (the bolt shops Slide the moving arm into the arm frame and attach the arm using a dog installed in the link arm assembly).
-
Page 8: Attach The Covers
Attach the covers Attach the base cover by fitting its plastic tab into the base frame, then slide the The EFX ships with the following cover parts: Two side covers, one front cover, cover forward and downward to snap it into place. and two cover retention brackets. - Page 9 4. Press the top of the covers together to engage the top internal latch. There are latches on the plastic covers that must be engaged to ensure a good fit. Review the follow procedure before starting the cover assembly. To attach the side covers: Position one of the side covers against the console frame with its ramp latch setting on top of the ramp and its wing edge fitted into the arm as shown below.
- Page 10 4. Press the front cover upward to close the gap between the covers and To complete the cover assembly: secure it using two screws Secure each side cover using one screw Note If the clip nuts are missing from your front cover, use the extra clip nuts included in your hardware kit.
- Page 12 EFX 700 Line Assembly Guide | P/N 304382-101 rev B, ENU ©2017 Precor Incorporated | January 2017...