Procedure 7.13 - Replacing An Eddy Current Magnet Assembly - Precor EFX 5.33 Service Manual

Procedure 7.13 - Replacing an Eddy Current Magnet
Procedure
1. Set the on/off switch in the "off" position, then unplug the power cord from the wall outlet.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Remove the left and right cover sections as described in Procedure 7.1.
3. For serial code AAAB, skip to step 10. For serial codes CR and ST, continue with step 4.
4. Disconnect the magnet cable from the magnet assembly. See Diagram 7.15.
5. Remove the bolts that secure the magnet assembly to the drive unit. Remove the magnet
from the drive unit.
Diagram 7.15 - Eddy Current Magnet (Serial codes CR and ST)
Assembly
5.33 Elliptical Fitness Crosstrainer
Magnet Cable
Mounting Bolts
Eddy Current
Magnet
Eddy Current
Disk
Page 59