Mitsubishi FX3U-20SSC-H User Manual page 53

FX -20SSC-H Positioning Block User's Manual
3U
2) Remaining travel distance operation mode
When the STOP command is turned ON, operation decelerates to a stop and the 20SSC-H enters
standby state for the remaining travel distance operation. At this time, "standby for remaining travel
distance" flag is turned ON. When the STOP command is OFF and the START command is turned ON
during standby status, positioning operation continues for the remaining travel distance.
Standby for remaining travel
distance after stopped
To cancel the remaining travel distance operation in the remaining
travel distance operation mode
When "remaining travel distance operation cancel command" is turned ON in standby status, the operation
for the remaining travel distance is cancelled and the positioning operation terminates.
Standby for remaining travel distance after stopped
Remaining travel distance operation cancel command
3. Wiring the stop switch
Connect the stop switch to the input terminal of the PLC.
For details of the PLC wiring method, refer to the following manual according to the PLC being used.
4. STOP command
Operate the PLC's STOP switch together with the 20SSC-H STOP command.
Speed
ON
START command
OFF
STOP command
Speed
ON
START command
OFF
STOP command
→ Refer to the FX
7 Before Starting Positioning Operation
7.4 Handling the STOP command
Control suspended
with STOP command
Remaining travel
distance operation
ON
OFF
ON
OFF
ON
OFF
Remaining travel distance operation
(Canceled remaining travel distance)
ON
OFF
ON
OFF
ON
OFF
→ Refer to the FX
Hardware Edition (Japanese document only)
3UC
Time
Time
Hardware Edition
3U
→ Refer to Section 7.4
47
1
2
3
4
5
6
7
8
9
10