Step 3: Drawing Measurement Regions - Omron F160 Operation Manual

Labeling
SeeAlso
CHECK
CHECK
3-13-3

STEP 3: Drawing Measurement Regions

The Measurement Conditions Settings Screen will be displayed.
Measurement conditions
Area
[ 0.000 :
Outside trimming :
Filling up holes
Sort
Area descending order
Label No.
End
2. Change the settings.
Refer to page 29 for details on inputting values.
The settings will be registered and the screen in (1.) will return.
Outside Trimming
Select Outside trimming when there is a white-pixel area inside the mea-
surement region that is not to be measured.
Input image
Measurement
region
Goal: To find the position
and area of this label
Filling Up Holes
Use the Filling up holes setting to specify how areas of black pixels con-
tained inside donut-shaped areas of white pixels are processed. If select-
ed, the black pixels will be processed as white pixels.
Input image
When a measurement region is drawn, measurement is performed for the dis-
played image and the results are registered as the reference values (area and
the position of center of gravity of the label number specified under Measure-
ment conditions). This position becomes the reference position for position
compensation, so be sure to place the measurement object in the correct posi-
tion before drawing the measurement region.
:
247808.000 ]
OFF
: OFF
:
: [ 0]
Outside triming: ON
The area outside the measurement
region changes to white pixels.
(The whole input image area is used
for measurement.)
The position and the size of the middle label
will be found if the following conditions are set:
Sort conditions: Area, ascending order
Label number: 1
Hole filling: ON
Section 3-13
Measurement target
159