Specifying Coordinate Axis - Omron F160 Operation Manual

Calibration
4-1-3

Specifying Coordinate Axis

192
The coordinates for the 1st point will be set and the Specifying Point
Screen for the 2nd point will be displayed.
5. Repeat steps 3 and 4 and specify 2 or more points.
Once point specification has been completed, a confirmation message will
be displayed.
Registering calibration
Parameters.
Execute Cancel
6. Select Execute.
The settings will be registered and the screen in (2.) will return.
This method is used to specify the coordinate axis while monitoring the mes-
sages displayed on the screen. The coordinate system, the origin, the rotation
angle, and the magnification, are set in that order. The magnification for X and
Y directions is the same setting when specifying the coordinate axis.
Coordinate System
Select the coordinate system.
Left-handed sytem
0
X
Origin
Positive direction
Y
1. Select Adjust/Calibration.
0.Scn 0 =SET= Adjust
Shutter Speed
Light control
Filtering order(Position)
Filtering(Position)
BGS levels(Position)
Filtering order(Measurement)
Filtering(Measurement)
BGS levels(Measurement)
Calibration
The initial screen for Calibration will be displayed.
Calibration
Sampling input
Specifying point
Specifying coordinate axis
Righthand
Parameter input
Lefthand
Reference parameter
2. Select Specifying coordinate axis.
3. Select Righthand or Lefthand.
Right-handed sytem
Y
Positive direction
0
X
Origin
Section 4-1