Drawing Measurement Regions - Omron F400 - 06-1999 Operation Manual

Menu Operations
3. Use the Up and Down Keys to move to the next item. The numeric value will be
2-1-5

Drawing Measurement Regions

This section explains drawing methods for model and measurement regions.
Use the Up, Down, Left, or Right Keys to move from one drawing point to another.
Press the Shift Key together with any one of these keys to move at a faster rate.
Types of Drawings
Type
Box
Ellipse
Circle
Circumference
Polygon
Note The type and number of drawings that can be created depends on the function in
which the drawings are being used.
Drawing Method (OR/NOT)
Drawing mode
OR Registers drawings as models or regions. If multiple drawings are made, all drawings will
be registered as one region.
NOT Used to delete part of a region.
Example 1: Drawing a Circumference
1. Using the Cursor Keys, set the center of the circle and press the ENT Key. The
12
set.
Upper[200]
Lower[128]
Set two diagonally opposing corners.
Set two diagonally opposing corners of a rectangle enclosing the
ellipse.
Set the center and radius.
Set the center and radius. and then the line width.
Specify up to 10 neighboring vertices. After specifying the last point,
press the ENT Key twice and it will be joined to the first point and the
region will be drawn.
1st figure (OR)
2nd figure (NOT)
center of the circle will be set. Use the SHIFT + Cursor Keys to move the cursor
quickly.
3
Drawing method
Meaning
2nd figure (OR)
1st figure (NOT)
The middle line is
the base of the
circumferences.
Section 2-1
— Filter/Pickup —