Step 4: Re-Registering Reference Values - Omron F160 Operation Manual

Labeling
3-13-4

STEP 4: Re-registering Reference Values

CHECK
CHECK
162
If Correct is selected, the cursor will be displayed. Correct the size and po-
sition of the figure as desired.
If Clear is selected, the selected figure will be cleared.
This operation is performed when only the reference values are to be re-regis-
tered.
When a measurement region is drawn, the measurement is performed for the
displayed image and the results are registered as the reference values. If the
re-registering function explained here is used, only the reference values for
the image currently displayed will be registered. The area and center of gravity
of the specified label number is registered for the reference value.
The reference position can be changed to enable the following function when
Region is selected.
Inspecting Positions from a Specified Point
Once the reference values (area and center of gravity) have been obtained for
the image currently displayed, the reference position is changed to an suitable
point. Position inspection can be performed by calculating the difference
between this reference position and the measurement position.
Reference position
changed to suitable point
When the measurement region is changed, the reference values return to the
default setting.
1. Select Reference registration.
0.Labeling
Binary
Measurement conditions
Region
Reference registration
Judgement conditions
Coordinate mode
A cursor will appear at the center of gravity of the label number set under
measurement conditions.
If the following conditions are set, the screen shown in the following dia-
gram will be displayed:
Measurement position (center of gravity)
Section 3-13