Behavior On Block Search, Dry Run, Program Testing, Simulation - Siemens SINUMERIK 840D sl Programming Manual

Description

2.3 Behavior on block search, dry run, program testing, simulation

2.3 Behavior on block search, dry run, program testing, simulation
Function
The measuring cycles are skipped during execution if one of the following execution modes is
active:
● "Trial run"
● "Program test"
● "Block search"
Simulation and simultaneous recording
Setting the measuring cycles under a simulated environment
Setting data SD55618 $SCS_MEA_SIM_ENABLE
= 0:
= 1:
Measuring cycles and measurement results under a simulated environment (SinuTrain) are
used for programming for training purposes if a real machine is not available. The
measurement results also involve "simulated" values, which can also deviate from the setting
in MD13231 MEAS_PROBE_OFFSET, but which are influenced by these.
16
($P_DRYRUN=1)
($P_ISTEST=1)
($P_SEARCH=1),
only if $A_PROTO=0.
The measuring cycles are exited without any function.
The measuring cycles are executed.
A distinction is made between the following simulation versions:
-Simulation in the HMI Operate editor
Traversing motion is visualized.
Measurement results and measurement result display are not available.
-SinuTrain
Measurement results and measurement result display are available.
Traversing motion can be visualized using the simultaneous recording function.
-For systems that exclusively operate with simulated axes (e.g. virtual machines,
NCU in a test rack application)
Measurement results and measurement result display are available.
Traversing motion can be visualized using the simultaneous recording function.
The following parameters should be observed for simulation in Sinutrain and
systems with simulated axes:
If MD13230 $MN_MEAS_PROBE_SOURCE = 1 to 8,
then set MD10360 $MN_FASTIO_DIG_NUM_OUTPUTS >= 1!
SD55619 $SCS_MEA_SIM_MEASURE_DIFF = input of simulated measure‐
ment difference
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles