Before Creating A Program - Mitsubishi Q68TD-G-H01 User Manual

6
PROGRAMMING
6.2.1
This section describes the steps to be taken before creating a program.
(1) Wiring of external devices
[Wiring diagram]
]
CH1
Thermocouple
CH2
Thermocouple
CH3
Thermocouple
(2) Intelligent function module switch setting
Figure 6.4 Intelligent function module switch setting: Thermocouple type setting

Before creating a program

Mount the Q68TD-G-H02 onto the base unit and connect a thermocouple K type to
CH1 to CH3.
For details, refer to Section 4.4.2.
Figure 6.3 Wiring diagram using a relay terminal block
Based on the setting conditions given in Section 6.2 (2), make the intelligent function
module switch setting.
(a) Setting details of each switch
1) Switch 1, Switch2: Thermocouple type setting
<Switch 2> <Switch 1>
0 0 0 0 0
H
CH8 CH7 CH6 CH5 CH4 CH3 CH2 CH1
6.2 Using Programs in Normal System Configuration
Relay terminal block
RTD
0 0 0
H
CH1 to CH3: 0 (Thermocouple K)
H
CH4 to CH8: 0 (Default value)
H
6.2.1 Before creating a program
1
2
3
4
5
6
7
8
6
- 6