Programming Procedure - Mitsubishi Q68TD-G-H01 User Manual

6
PROGRAMMING
6.1

Programming Procedure

Create a program that executes temperature input of the Q68TD-G-H02(H01) in the
following procedure.
YES
Initial settings, Auto refresh
setting
(Refer to Section 6.2.2,
Section 6.3.1)
Disconnection detection signal (Q68TD-G-H02 only)
Disconnection detection flag (Q68TD-G-H02 only)
Disconnection state monitor signal
(Q68TD-G-H01 only)
Disconnection state monitor flag
(Q68TD-G-H01 only)
Start
Use the utility package?
NO
Conversion enable/disable setting
Averaging process selection
Averaging processing selection
Sampling processing
Time average
Count average
Moving average
Primary delay filter
Perform warning output?
NO
Output a scaling value?
NO
Procedure to judge
disconnection status
monitor?
Operating condition setting request (Y9)
processing
Measured temperature value read
End
Figure 6.1 Programming chart
YES
Warning output enable/disable
Process alarm upper/lower limit values
Rate alarm warring detection period
Rate alarm upper/lower limit values
<Set depending on necessity>
YES
Set the scaling range setting
Measured temperature value
Set the disconnection detection conversion setting
(Q68TD-G-H02 only) or disconnection state conversion setting
(Q68TD-G-H01 only).
Up scale
Down scale
Given value
(Set any value for the disconnection detection
conversion setting (Q68TD-G-H02 only) or disconnection
state conversion setting (Q68TD-G-H01 only).)
<Select any of them>
6.1 Programming Procedure
1
2
3
4
5
Initial setting
(Refer to
Section
6.2.3)
6
7
8
6
- 2