Ricoh D009 Service Manual page 531

Do not put multiple machine firmware programs on the same SD card. Copy
the only model firmware you want.
1. Turn the main power switch off.
2. Remove the slot cover (
3. Insert the SD card into SD Card Slot 2. Make sure the label on the SD card faces the
rear side of the machine.
4. Slowly push the SD card into the slot so it locks in place. You will hear it click. Make sure
the SD card locks in place.
To remove the SD, push it in to unlock the spring lock. Then release it so it pops
out of the slot.
5. Disconnect the network cable from the copier if the machine is connected to a network.
6. Switch the main power switch on. After about 45 seconds, the initial version update
screen appears on the LCD in English.
7. On the screen, touch the button or press the corresponding number key on the
operation panel to select the item in the menu that you want to update.
ROM/NEW What it means
Tells you the number of the module and name of the version
ROM: currently installed. The first line is the module number, the second
line the version name.
Tells you the number of the module and name version on the SD
NEW: card. The first line is the module number, the second line the
version name.
Controller, engine and operation panel firmware cannot be updated at the same
time. It is recommended to update firmware modules one by one.
8. Touch "UpDate (#)" (or
While downloading is in progress, the LCD will display "Loading". When
downloading has been completed, the panel will display "update done".
For operation panel software, the Start key lights red while downloading is in
progress, and then lights green again after downloading is completed.
9. The "Update is Done" message appears on the operation panel after completing the
SM
x 1).
) to start the update.
5-245
Updating the Firmware
D009/D011/D012/D013