Ricoh D009 Service Manual page 618

Image Fusing
SP Settings for Post-Job Cleaning
The previous description of stripper cleaning with drum rotation after small, medium, and
large print jobs is based on the default settings of SP3905. These settings can be adjusted.
These are the SP codes that control how cleaning is done at the end of a job.
No.
3905-001 1st Cleaning: Interval
3905-002 1st Cleaning: Mode Setting
3905-003 2nd Cleaning: Interval
2nd Cleaning: Mode
3905-004
Setting
3905-005 3rd Cleaning: Interval
3905-006 3rd Cleaning: Mode Setting
Here are some important points to keep in mind about hot roller stripper cleaning:
If the machine switches to any of the energy saver modes (low power mode, etc.) while
cleaning is in progress, the cleaning cycle will not be interrupted.
The cleaning cycle is not interrupted by free rotation of the hot roller when the machine is
getting ready to print.
Opening the front door, however, while cleaning is in progress will stop a cleaning cycle, and
the remaining part of the cleaning cycle is cancelled.
D009/D011/D012/D013
Name
Sets the number of pages (accumulative total)
to print before "1st Cleaning Mode" is done.
(Default: 5)
Sets the number of additional execution times
of cleaning A for "1st Cleaning Mode"
(Default: 0)
Sets the number of pages (accumulative total)
to print before "2nd Cleaning Mode" has been
done. (Default: 30)
Sets the number of additional execution times
of cleaning A for "2nd Cleaning Mode"
(Default: 0)
Sets the number of pages (accumulative total)
to print before "3rd Cleaning Mode" is done.
(Default: 100)
Sets the number of additional execution times
of cleaning B for "3rd Cleaning Mode"
(Default: 0)
6-68
Function
SM