Lexmark X746de Service Manual page 53

Error code Action
39 Complex Page The page is too complex to print. Options are:
50 PPDS Font Error
51 Defective Flash
52 Flash Full
53 Unformatted Flash
54 Serial option <x>
error
54 Std Network
Software Error
55 Unsupported Option
in Slot <x>
If this does not fix the problem, replace the system board. See
page
56 Standard Parallel
Port Disabled
Not in IRs
• Touch Continue to continue. The job may not print correctly.
• Cancel the job.
• Additional memory may fix the problem.
• Touch Continue to clear the message and continue printing. The job may not print
correctly.
• Cancel the current job.
• If this does not fix the problem, replace the system board. See
on page 4-157.
• Touch Continue to clear the message and continue printing.
• Install different flash memory before downloading any resources to flash.
• If this does not fix the problem, replace the system board. See
on page 4-157.
• Touch Continue to clear the message and continue printing.
Note: Downloaded fonts and macros not previously stored in flash memory are deleted.
• Delete fonts, macros, and other data stored in flash memory.
• Install a larger capacity flash memory card.
• If this does not fix the problem, replace the system board. See
on page 4-157.
• Touch Continue to clear the message and continue printing.
• Format the flash memory before storing any resources on it. If the error message
remains, replace the flash memory.
• If this does not fix the problem, replace the system board. See
on page 4-157.
• Make sure the serial link is set up correctly and the appropriate cable is in use.
• Make sure the serial interface parameters (protocol, baud, parity, and data bits) are set
correctly on the printer and host computer.
• Touch Continue to clear the message and continue printing.
The job may not print correctly.
• POR the printer. If this does not fix the problem, replace the PCI card.
• Touch Continue to clear the message and continue printing. The job may not print
correctly.
• Program new firmware for the network interface.
• POR the printer. If this does not fix the problem, replace the PCI card.
1. Turn the printer off.
2. Unplug the power cord from the wall outlet.
3. Remove the unsupported option.
4. Connect the power cord to a properly grounded outlet.
5. Turn the printer on.
4-157.
• Touch Continue to clear the message. The printer discards any data received through
the parallel port.
• Make sure the Parallel Buffer menu item is not set to Disabled.
• If this does not fix the problem, replace the PCI card.
7526
"System board removal"
"System board removal"
"System board removal"
"System board removal"
"System board removal" on
Diagnostic information
2-13
Previous
Next
Go Back