Printer Setup - Lexmark X746de Service Manual

To interpret the test:
• xxxx Bad Blocks/yyyyyy Usable is displayed if fewer than 2000 bad blocks are detected. xxxx
indicates the number of bad blocks, and yyyyyy indicates the number of usable blocks.
xxxx Bad Blocks/Replace Disk is displayed if more than 2000 bad blocks are detected. The disk
•
cannot be recovered because too many bad blocks exist on the disk.
Press to return to DEVICE TESTS.
Flash Test
This test causes the file system to write and read data on the flash to test the flash.
Warning: This test destroys all data on the flash because the flash is reformatted at the end of the test.
To run the Flash Test:
Touch DEVICE TESTS from the Diagnostics Menu.
1.
Touch Flash Test.
2.
The power indicator blinks while the test is running.
•
Flash Test/Test Passed is displayed if the test passes and the power indicator turns on solid.
•
Flash Test/Test Failed is displayed if the test fails and the power indicator turns on solid.
•
Press to return to DEVICE TESTS.

Printer Setup

Defaults
U.S./Non-U.S. defaults changes whether the printer uses the U.S. factory defaults or the non-U.S. factory
defaults. The settings affected include paper size, envelope size, PCL symbol set, code pages, and units of
measure.
Warning: Changing this setting resets the printer to factory defaults, and data may be lost. It cannot be undone.
To change the Defaults:
Touch PRINTER SETUP in Diag Menu.
1.
Touch Defaults.
2.
3. Select from U.S. or Non-U.S., and then touch Submit.
Page Counts
You can view, but not change any of the three counts displayed under PAGE COUNTS.
The view the Prt Color Pg Count, the Prt Mono Pg Count, or the Perm Page Count:
Touch PRINTER SETUP in Diag Menu.
1.
Select the page count you wish to view:
2.
Prt Color Pg Count
•
Prt Mono Pg Count
•
• Perm Page Count
Touch Back to return to the Diagnostics Menu.
7526
Previous
Go Back
Diagnostic aids
3-21
Next