Slim Select Bay Module - Toshiba TECRA M9 Maintenance Manual

4 Replacement Procedures
4.6

Slim select bay module

Removing the slim select bay module
The following describes the procedure for removing the slim select bay module. (See Figure
4-9 and 4-10.)
The explanation and figure shown below are the optical disk drive removing/installing.
CAUTION: Do not put fingers in the slot for the slim select bay module. It may cause
injury.
1. Remove the following screw securing the latch and drive the removed screw into the
screw hole. (The slim select bay is unlocked.)
• M2.5×4B
2. While sliding the latch toward the arrow direction in the Figure 4-9 and pull out the
slim select bay module while holding the hook to disconnect it from the connector of
the system board.
M2.5×4B FLAT HEAD
Slim select bay module
Hook
4-18 [CONFIDENTIAL]
FLAT HEAD screw
Figure 4-9 Removing the slim select bay module
4.6 Slim select bay module
×1
TECRA M9 Maintenance Manual (960-631)
Screw hole
Latch