Toshiba TECRA M9 Maintenance Manual page 271

4.14 Cover assembly and Base assembly
3. Turn over the computer and open the display.
4. Disconnect the LCD cable, speaker cable, switch cable and finger print sensor
cable from the connector CN5000, CN6170, CN9500 and CN9550 on the system
board.
5. Remove the following screws.
• M2×4B
• M2.5×8B
6. Separate the cover assembly and base assembly.
Speaker cable
(Connected to CN6170)
Switch cable
(Connected to CN9500)
LCD cable
(Connected to CN5000)
Base assembly
Figure 4-25 Removing the cover assembly and base assembly (2)
TECRA M9 Maintenance Manual (960-631)
BIND screw
FLAT HEAD screw
M2.5×8B FLAT HEAD
4 Replacement Procedures
×1
×1
M2×4B BIND
Finger print sensor cable
(Connected to CN9550)
Cover assembly
[CONFIDENTIAL] 4-37