Fingerprint Sensor Board - Toshiba TECRA M9 Maintenance Manual

Hide thumbs Also See for TECRA M9:

Table of Contents

4.15 Fingerprint sensor board

Replacement Procedures

4.15 Fingerprint sensor board

Removing the Fingerprint sensor board

The following describes the procedure for removing the fingerprint sensor board. (See Figure

4-26 and 4-27.)

1. Push the hook down and remove the fingerprint sensor board hold plate while

sliding it in the direction of the arrow in the figure below.

2. Peel off the glass tape.

Figure 4-26 Removing the fingerprint sensor board hold plate

TECRA M9 Maintenance Manual (960-631)

4 Replacement Procedures

Fingerprint sensor board hold plate

[CONFIDENTIAL]

Table of Contents