Toshiba TECRA M9 Maintenance Manual page 287

Hide thumbs Also See for TECRA M9:

Table of Contents

4.22 North bridge heat sink/CPU heat sink/Fan/CPU

Installing the North bridge heat sink/CPU heat sink/Fan/CPU

The following describes the procedure for installing the North bridge heat sink/CPU heat

sink/fan/CPU. (See Figure 4-34 to 4-39.)

1. Make sure that the cam of the CPU socket is in the unlock (OPEN) position.

2. Install the CPU on the CPU socket and check the CPU is installed on the correct

3. Lock the CPU by rotating clockwise the cam on the CPU socket by 90 degrees with a

flat-blade driver.

TECRA M9 Maintenance Manual (960-631)

Figure 4-38 Installing the CPU

4 Replacement Procedures

[CONFIDENTIAL]

Chapters

Table of Contents