Toshiba TECRA M9 Maintenance Manual page 251

4.5 HDD
Installing the HDD
The following describes the procedure for installing the HDD. (See Figure 4-6 to 4-8.)
CAUTION: Do not hold the HDD by its top and bottom face. It may damage the HDD.
1. Seat the HDD in the HDD holder and secure them with the following screws.
• M3×4C
CAUTION: Do not apply pressure to the middle of the HDD assembly. It may damage
the HDD assembly. Hold the HDD assembly by its corners.
2. Set the connector of the HDD cable upward and connect the HDD assembly to the
connector. Press the HDD assembly to ensure a firm connection.
3. Set the HDD assembly into the slot.
4. Seat the HDD slot cover and secure it with the following screws.
• M2.5×16B
• M2.5×8B
TECRA M9 Maintenance Manual (960-631)
FLAT HEAD screw
FLAT HEAD screw
FLAT HEAD screw
4 Replacement Procedures
×4
×1
×1
[CONFIDENTIAL] 4-17