Table of Contents
Advertisement
7462
d. Use the copy of the Quick Test page to adjust the Left Margin and Top Margin settings.
e. Touch Submit.
f. Touch Copy Quick Test and compare the new copy to the original. Repeat the flatbed
alignment steps until the position on the page of the Quick Test copy closely matches the
original.
To align the ADF:
a.
Do one of the following:
•
To align the ADF front: place the Quick Test page face up, short edge first into the ADF.
•
To align the ADF back: place the Quick Test page facedown, short edge first into the ADF.
b. Touch Copy Quick Test.
The scanner prints a copy of the Quick Test page.
c. Touch ADF Front or ADF Back.
d. Use the copy of the Quick Test page to adjust the Horizontal Adjust and Top Margin settings.
e. Touch Submit.
f. Touch Copy Quick Test and compare the new copy to the original.
Repeat the ADF alignment steps until the position on the page of the Quick Test copy closely matches the
original.
Touch Back to cancel and return to the Configuration Menu
Disable Scanner
To change this setting, touch
1. Touch
or
The settings are Enable, Disable and ADF Disable.
2. Touch Submit to save your change.
Touch Back to exit without changing the value.
Paper Prompts
When a tray is out of the indicated paper size, a prompt is sent to the user to load paper in a tray. This setting
controls the tray the user is directed to fill.
1. Touch
to select Paper Prompts from the Configuration Menu.
The panel displays the setting's name in the header and
row.
2. Touch
or
The values are Auto (default), MP Feeder, and Manual Paper.
3. Touch Submit to save the change.
Touch Back to exit without changing the value.
Envelope Prompts
This setting controls the tray the user is directed to refill when a specific envelope size is out. The selections
are Auto (default), MP Feeder, and Manual Envelope.
1. Touch
to select Envelope Prompts from the Configuration Menu.
The panel displays the setting's name in the header and
row.
2. Touch
or
The values are Auto (default), MP Feeder, and Manual Envelope.
3. Touch Submit to save the change.
3-36
Service Manual
to select Disable Scanner from the Configuration Menu.
to change the setting.
to change the value.
to change the value.
[setting's current value]
below the header
[setting's current value]
below the header
Previous
Next
Go Back
Advertisement
Table of Contents
