Table of Contents
Advertisement
7462
Stapler/stacker controller card assembly removal
1. Remove the left left cover. See
2. Disconnect all harnesses to the controller card.
3. Remove the three screws (A) securing the stapler/stacker controller card assembly.
4. Remove the stapler/stacker controller card assembly.
Offset stacker paddle drive motor assembly removal
1. Remove the left left cover. See
2. Disconnect the paddle motor harness from the controller card.
3. Remove the cable from the harness clip.
4-246
Service Manual
"Offset stacker left cover removal" on page
A
"Offset stacker left cover removal" on page
4-238.
4-238.
Previous
Next
Go Back
Advertisement
Table of Contents
