Lexmark MB790MFP Service Manual page 417

7462
3. Pull slack in the carriage belt, and retighten screw (A).
4. Slide the carriage belt out of the rear of the scanner CCD assembly.
5. Remove the rear CCD scanner shaft (B) from the flatbed frame, by lifting the left end of the shaft up and
remove through the left side.
B
6. Lift the scanner CCD assembly from front shaft.
7. Rotate the scanner CCD assembly upside down, and carefully remove the ribbon cable.
8. Remove the scanner CCD assembly.
Replacement note: You must adjust skew after reinstalling the scanner CCD assembly. Go to
skew" on page
4-92
Service Manual
A
3-93.
Previous
Next
Go Back
"Adjusting