4-bin mailbox assembly left cover removal
1. Place the 4-bin mailbox assembly on its side.
2. Remove the two screws (A) on the underside of the 4-bin mailbox assembly securing the left cover.
3. Using your finger, pull up on the top surface of the left cover while simultaneously pulling out, and remove.
4-bin mailbox assembly controller card assembly removal
1. Remove the 4-bin mailbox assembly left cover. See
page
4-221.
2. Disconnect all harnesses from the controller card.
Note: Label each deflector gate solenoid cable for correct replacement upon installation.
A
"4-bin mailbox assembly left cover removal" on
Repair information
7462
Previous
Next
Go Back
4-221