Table of Contents
Advertisement
Refer to your modem documentation for guidelines about establishing an
asynchronous DCE-to-DCE connection between these two devices through the
public switch telephone network (PSTN). Use the RJ-45 to DB-9 (or DB-25)
adapter cable to connect the router to a modem.
1.
Connect the RJ-45 connector to the Auxiliary port on the iBG3026 router.
2.
Connect the other end of the DB-9 (or DB-25) connector cable to the
modem.
3.
Connect the modem to a telephone line using a standard twisted-pair
cable with modular RJ-11 connectors.
4.
Repeat steps 2 and 3 on the remote terminal or workstation side.
5.
Configure modems for 9600 bps, 8 data bits, 1 stop bit, no parity, and
hardware flow control.
Refer to your modem documentation if necessary. If a workstation is
used for the console, use VT-100 terminal emulation software or
equivalent, and configure the software as specified for modems.
© SAMSUNG Electronics Co., Ltd.
The default serial configuration is DTE. To use the IBG3026 as DCE
equipment, you must reconfigure the interface and reboot the router.
Do not configure the modem to 'send result codes' or 'echo' commands.
Doing so may cause the router to hang.
A modem connected to the Console port of an iBG3026 router and set
for verbose mode (configured to 'send result codes' or 'echo'
commands) can prevent the router from booting up properly. iBG3026
networks recommends that the user configures the modem for quiet
(nonverbose) mode when it is connected to the router console port.
Ubigate iBG3026 Installation Manual/Ed.01
29
Advertisement
Table of Contents
