Table of Contents
Advertisement
3.
If the slot is to remain empty, cover the hole with a slot cover by aligning
the slot cover's screws with the screw holes on the slot bay.
4.
Tighten the retaining screws to secure the slot cover.
Installing Internal Option Card
To add the internal option card:
1.
Pull the main module straight out of the slot bay.
2.
Insert internal option card into the card connector of the main board.
3.
Tighten the screws to fully seat the internal option card.
To remove the internal option card already installed:
1.
Loosen the screws.
2.
Disconnect internal option card from the main module.
© SAMSUNG Electronics Co., Ltd.
Figure 4.60 Installing the Internal Option Card
Ubigate iBG3026 Installation Manual/Ed.01
77
Advertisement
Table of Contents
