Table of Contents
Advertisement
CHAPTER 4. Module and Internal Option Card Installation
To remove a module already installed in the iBG3026:
1.
Locate the slot from which you plan to remove an installed module.
2.
Loosen the two retainer screws.
3.
Pull the module straight out of the module bay.
4.
If the slot is to remain empty, cover the hole with a slot cover by aligning
the slot cover's screws with the screw holes on the slot bay.
5.
Tighten the retaining screws to secure the slot cover.
Installing LMG-44/LMGP-44 Module
To add a LMG-44/LMGP-44 module to the iBG3026 chassis:
1.
To remove the mid-span support in order to install the LMG-44/LMGP-
44 module.
74
Figure 4.56 Removing the Mid-span Support
© SAMSUNG Electronics Co., Ltd.
Advertisement
Table of Contents
